EPA Lead Test Check Kit/16

LeadCheck® Swabs ...
... are non-hazardous and provide a rapid, sensitive and specific test for leachable lead on any surface ... including toys! When lead is detected, LeadCheck® Swabs turn pink or red on contact, depending on the concentration of lead present. In the vast majority of test situations results are obtained in less than 30 seconds. When detecting low levels of lead, or lead chromate containing pigments, results may take longer to develop. Each kit contains test confirmation cards which should be used to verify test results.Swab Activation
LeadCheck® Swabs are self–contained test units which provide a rapid, easy to use, sensitive and specific test for lead on any surface.
Each swab contains two crushable vials (see diagram).

A lead reactive dye is stored in one ampoule. The second ampoule contains a pre-measured "activator" solution to ensure a proper reaction. When a swab is activated by crushing the vials and mixing the contents, and the tip is brought in contact with lead, a pink (or red) compound characteristic of lead forms. A confirmation card containing a small quantity of lead is included with the product to prove that tests were performed properly.

Principle of Method
LeadCheck® Swabs are based on the reactivity of lead with certain compounds capable of forming strongly colored complexes with lead. When used, a pink color that is specific for lead develops within 30 seconds and is stable for hours.

Sensitivity
In defined laboratory tests, LeadCheck® Swabs reproducibly detect down to 2 micrograms of lead. In field tests conducted by two separate, independent inspection firms, LeadCheck® Swabs reliably detect 0.5% lead in paint with virtually 100% accuracy.

Background
Paint - The U.S. Government banned the use of lead in domestic paint in 1978. Buildings built before that time are likely to contain surfaces covered in lead based paint. Levels of lead exceeding one milligram/cm2 are considered to be hazardous by the Federal Government.

Solder - Lead-containing solder is the major source of lead in potable water. In 1986 the U.S. Government amended the Safe Water Drinking Act and banned the use of solder or flux exceeding 0.2% lead content or pipes or fittings exceeding 8%.

Applications
LeadCheck® Swabs can be used to detect lead on any surface. This method offers rapid and reliable test for lead in:

* Imported toys and ceramics.
* Paint of any color on any surface.
* Steel Structures such as bridges and water towers.
* Waste material.
* Solder and plumbing fixtures.
* Sand blasting media.
* Soil and dust.
Learn More

Utivac HEPA Vacuum Learn More

4 gallon dry HEPA vacuum



The Euroclean GD 930 Series canister vacuum offers three versions to meet a wide range of cleaning needs. The large 4 gallon dust bag allows for extended cleaning time and the true H.E.P.A. filtration filters 99.97% of particles 0.3 microns and larger.

The GD 930 canister vacuum is quite simply our biggest, most powerful and best canister vacuum. It features our largest dust bag (4 gallons) so that you can vacuum longer without having to stop and change bags. Both standard and high filtration bags are offered. The H.E.P.A. GD 930 models feature an oversized true DOP MIL-STD-282 H.E.P.A. filter mounted before the motor. The huge surface area results in less restricted air flow to maximize vacuum performance no matter what type of material is being vacuumed. With 2,880 square inches of filter media, the filter can be used longer before it needs to be replaced.
Learn More

Ever had to do a project in your house involving sanding
and get dust everywhere? Tried to put up a plastic barrier
only to waste your time and still get dust in every place you look? Well now you can put up a virtually airtight plastic dust barrier in minutes! Award winning Zip Walls control dust, are lightweight and portable, are easy to assemble, virtually airtight, and install in minutes. One person can erect a 20 foot long ZipWall® barrier in less than one minute, saving a time and money.

The 4 Pack Plus is a great starter kit for contractors, maintenance crews and home owners. You can create a temporary dust barrier up to 30 feet long without the use of tape, staples or ladders. Consider the labor savings of a ZipWall system: A 30 foot long 10 foot high barrier took 1 hour to erect using conventional methods. With the ZipWall system, the same barrier can be completed by one person in under 5 minutes. It also prevents costly repairs to painted surfaces because no tape or staples are used. And it increases customer satisfaction and referrals.

The 4 Pack Plus also gives you the option of creating a barrier system with even better dust containment performance. Simply replace the standard SLP pole head with a T-Clip and Foam Rail, and then raise the SLP pole to press the Foam Rail against the plastic sheeting at the ceiling.

Suggested Uses:

* Floor finishing
* Carpentry
* Painting
* Demolition
* Window installation.
* Flood light support
* Holding up cabinets
* Adhering ceiling tiles
* Installing crown moulding
* Sheet rock support

The included Carry Bag makes it easy to store and transport your ZipWall system and it can hold up to 12 SLP poles. The SLP head and plate assembly clamp the plastic sheeting tightly; while the twist-locking telescoping pole lets you raise the sheeting to the ceiling without a ladder. The exclusive spring loading feature at the top of the pole lets you lift and tuck the sheeting under the foot of the pole, keeping it under tension at all times.

SLP poles extend from 4 feet 7 inches to 12 feet. They are clear anodized and weigh just 1.5 lbs each. Poles should be placed every 8' to 10' or closer if there is a lot of air movement. Use a Grip Disk under each pole to secure it on smooth flooring like vinyl or wood. SLP poles can accept any plastic or cloth sheeting up to 8 mils thick and can support up to 110 lbs. For even better dust containment, use our Tight-Seal accessories with SLP poles.

Features:

* Easy, quick assembly
* Pro-quality/durability; sets up fast; no tape, no staples, no ladders
* No damage to finished surfaces
* Create a 30’ barrier with one person in under 5 minutes
* Carry bag to neatly store and take everything with you
* Use T-Clip and Foam Rail for even better dust containment
* Poles extend from 4 feet 7 inches to 12 feet.
* Foam Rail™, push plastic sheeting at the ceiling for improved dust containment
* Patented spring loaded pole lets you lift and tuck the sheeting under the pole
* Carry Bag can store up to 12 SLP poles
* Pole can accept any plastic or cloth sheeting up to 8 mils thick, can support up to 110 lbs.

Specifications:

* Kit contains the following:
o 4 SLPs (Spring Loaded Pole)
o Head, plate, tether, and Grip Disk for each pole
o 2 Foam Rails,
o 2 T-Clip adaptors,
o 1 box of Standard Zipper
o 1 Carry Bag
* SLP poles are clear anodized and weigh just 1.5lbs each
* Poles hold up to 110 pounds
* Poles extendable to 12 feet
* Uses sheeting up to 8 mils thick
* One year warranty

Learn More

ead wipes are used for the collection and sampling of lead in settled dust. Our formulation does not contain lanolin, aloe, or other interfering oils which may alter lab test results. The rayon substrate is easily digested in nitric acid. Learn More

This Carry Bag guarantees storage and transport efficiency because contractors can keep all of their ZipWall® elements organized and in good condition, ready to travel to and from jobs.

Carrying Bag


This durable and attractive bag is designed to hold all your ZipWall products. It is made of rugged polyester and has plenty of room for standard SLP poles, Kit 20 poles, Foam Rail cross bars, Side Clamp wall mounts, or any combination of ZipWall products. It can hold the equivalent of 12 SLP poles.
Learn More

* Fits non-spring-loaded poles
* Includes head, plate and tether
* 30-day, money-back satisfaction guarantee!


Replacement Zipwall Jack, comes complete with Head (MI-ZIPHEAD-EA), Plate (MI-ZIPPLATE-EA), and tether. Fits on 20-foot and older non-spring-loaded zip poles. Will also fit on most standard threaded poles. Learn More